Your cart is currently empty!
Shipping class: Mailbox package
Jumper wire 10 cm 4pin female/female
Jumper wire 10 cm 4pin female/female
Jumper wire 20 cm 2pin female/female
Use this jumper wire, for example, to connect sensors and actuators with SDA/SCL pins
Jumper wire 20 cm 3pin female/female
Jumper wire for connecting sensors with 3 pins, for example, a light sensor or line-following sensor
Jumper wire 20 cm 4pin male/female
Jumper wire 20 cm long with 4 pins on 1 side and 4 ports (male/female) on the other side
Color sensor
Leaphy also recognizes color surfaces with this sensor. This makes a line course even more challenging! Please note that soldering is necessary!
Leaphy Delphy shield
The Leaphy Delphy shield can be used for the Leaphy Flitz. Together with a regular nano (Note only the 5Volt variants) you can control up to 3 servos, connect various analog and digital sensors. The power supply must be between 3 and 16 volts and must not exceed 3.6 amps. In practice, a battery holder…
Solution book Leaphy original
Led strip
Give Leaphy a unique “look” with the Ledstrip. With the special Ledstrip programming blocks, you can create all kinds of patterns. Please note that soldering is necessary!
Light sensor Leaphy
With this analog light sensor, your Leaphy robot measures exactly how much light is in the environment.
TT Motor (for Leaphy Original) jumper 10 cm male
Motor shield
OLED screen
Visualize your measurements from the sensors on your robot with an OLED screen. To be programmed with the ‘Set display’ command block in Leaphy Easybloqs.
RGB and motion sensor
This Leaphy sensor is actually 2 sensors in 1. It is a color sensor that allows your Leaphy robot to perceive colors. In addition, it is a motion sensor, the sensor can detect movement from top to bottom, bottom to top, left to right and right to left.
RGB Led single
RGB Led can give light in the colors Red, Green and Blue and all mixed colors. This RGB LED is also found in the Flitz and the Clickjort
RGB Led trio
RGB led module with 3 individual led lights always with equal color.
Servo MG90 (only for 5v Delphy shield and Uno)
Servo MG90 rotates between 0 and 180 degrees