Shipping class: Mailbox package
-
Jumper wire 10 cm 4pin female/female
Jumper wire 10 cm 4pin female/female
-
Jumper wire 20 cm 2pin female/female
Use this jumper wire, for example, to connect sensors and actuators with SDA/SCL pins
-
Jumper wire 20 cm 3pin female/female
Jumper wire for connecting sensors with 3 pins, for example, a light sensor or line-following sensor
-
Jumper wire 20 cm 4pin male/female
Jumper wire 20 cm long with 4 pins on 1 side and 4 ports (male/female) on the other side
-
Color sensor
Leaphy also recognizes color surfaces with this sensor. This makes a line course even more challenging! Please note that soldering is necessary!
-
Leaphy Delphy shield
The Leaphy Delphy shield can be used for the Leaphy Flitz. Together with a regular nano (Note only the 5Volt variants) you can control up to 3 servos, connect various analog and digital sensors. The power supply must be between 3 and 16 volts and must not exceed 3.6 amps. In practice, a battery holder
-
Solution book Leaphy original
-
Led strip
Give Leaphy a unique “look” with the Ledstrip. With the special Ledstrip programming blocks, you can create all kinds of patterns. Please note that soldering is necessary!
-
Light sensor Leaphy
With this analog light sensor, your Leaphy robot measures exactly how much light is in the environment.
-
TT Motor (for Leaphy Original) jumper 10 cm male
-
Motor shield
-
OLED screen
Visualize your measurements from the sensors on your robot with an OLED screen. To be programmed with the ‘Set display’ command block in Leaphy Easybloqs.
